ImagePerfect™ 2706 Perforated Window Film
60% printable surface with 1.5mm holes, Permanent
ImagePerfect™ 2706 is a promotional perforated window film with a 60% printable surface and 1.5mm holes which has been specifically designed for printing with all solvent inks but is also suitable for latex ink.
UV-cured inks have a tendency to block the small perforations, thereby restricting the view from the reverse side.
IP 2706 can be used on flat surfaces and is intended for indoor and short-term outdoor applications.
When printed the film offers two different views: the front side with the graphic, the reverse side with a clear view through the perforations.
Do not use wet application.
*The adhesive is removable for up to one year after application, beyond that it will have permanent properties. To obtain a good through vision and protection against moisture and abrasion we recommend overlaminating.
Laminate: IP 2830-100.
|Interior or Exterior use||
|Minimal Temperature Resistance||-40.0 °C|
|Maximal Temperature Resistance||80.0 °C|
|Curve Format||Flat surfaces|
Adhesive & Liner
|Adhesive||Acrylic black, permanent|
|Adhesive Composition||Water-based acrylic|
|Adhesive Strength||12.0 N/25mm|
|Material used as liner||PE-coated silicone paper, 135g/m²|
|Fire Rating||Self-extinguishing when adhered to steel|
|Shelf Life||2 years (20°C / 50% relative humidity)|
|Durability (range)||Up to 1 year|
Not suitable for wet application. For use in wet conditions and vehicle applications lamination is highly recommended. *The adhesive is removable for up to one year after application, beyond that it will have permanent properties.
The laminate should overlap the PWF by 5mm and then there should be a 1mm gap between the edge of the laminate and the edge of the window, (a 6mm gap in total between the edge of the PWF and the edge of the window).
The 5mm overlap on the PWF is required to give the laminate/PWF construction more process security and resistance to high-pressure washing systems.
The 1mm gap between the edge of the laminate and the edge of the window is required to ensure that there is no physical contact between the laminate and the rubber seal that would invariably be present in the window and which would encourage plasticiser migration.